A Beginner’s Guide to Connecting a Load Cell to an Arduino Uno using HX711


If you are new to the world of load cells and Arduino, you may be wondering how to connect them together to create a successful project. In this beginner’s guide, we will walk you through the steps of connecting a load cell to an Arduino Uno using the HX711 amplifier.

First of all, let’s start by understanding what a load cell is. A load cell is a transducer that converts force or weight into an electrical signal. It is commonly used in industrial applications and measurement systems where accurate weight measurements are required.

Now, let’s move on to the Arduino Uno. The Arduino Uno is a popular microcontroller board that is widely used in the maker community for various projects. It is easy to use and has a large community of users who share their knowledge and resources online.

To connect a load cell to an Arduino Uno, we will need an HX711 amplifier. The HX711 is a precision 24-bit analog-to-digital converter (ADC) designed for weigh scales and industrial control applications.

Here is a step-by-step guide to connect a load cell to an Arduino Uno using the HX711 amplifier:

1. Connect the load cell to the HX711 amplifier

First, connect the load cell to the HX711 amplifier. The load cell has four wires – red, black, white, and green. Connect the red and black wires to the E+ and E- terminals on the HX711 amplifier, respectively. Then, connect the white and green wires to the A+ and A- terminals on the HX711 amplifier, respectively.

2. Connect the HX711 amplifier to the Arduino Uno

Next, connect the HX711 amplifier to the Arduino Uno. Connect the VCC and GND pins of the HX711 to the 5V and GND pins on the Arduino Uno, respectively. Then, connect the DT and SCK pins of the HX711 to any digital pins on the Arduino Uno (e.g., digital pins 2 and 3).

3. Write the Arduino code

Now, write the code for the Arduino Uno. You can use the HX711 library available online to interface with the HX711 amplifier. The code should read the weight data from the load cell through the HX711 amplifier and display it on the serial monitor.

4. Upload the code to the Arduino Uno

Finally, upload the code to the Arduino Uno using the Arduino IDE. Open the serial monitor to see the weight data being displayed in real-time.

In conclusion, connecting a load cell to an Arduino Uno using the HX711 amplifier is a simple and straightforward process. By following the steps outlined in this beginner’s guide, you can easily create your own weighing scale or measurement system using these components. So, go ahead and start experimenting with load cells and Arduino to bring your ideas to life!

https://maps.app.goo.gl/jgBjMS3mZYiTGFWx9

Leave a Comment