[ad_1]
If you are looking to connect multiple HX711 load cells to an Arduino for your project, you’re in luck! In this step-by-step guide, we will show you how to do just that. The HX711 is a precision 24-bit analog-to-digital converter (ADC) designed for weigh scales and industrial control applications. By connecting multiple HX711 load cells to an Arduino, you can create a high-precision weighing system that can be used in a variety of applications.
Before we begin, you will need the following supplies:
1. Arduino board (such as the Arduino Uno or Arduino Nano)
2. HX711 load cell amplifier modules (one for each load cell)
3. Load cells (one for each sensor)
4. Breadboard and jumper wires
5. Power supply (5V)
6. Computer with Arduino IDE installed
Step 1: Gather your supplies and assemble your load cell setup
First, you will need to gather all of your supplies and assemble your load cell setup. Connect each HX711 load cell amplifier module to an individual load cell using jumper wires. Make sure to connect the appropriate wires to the excitation, signal, and ground pins on each module.
Step 2: Connect the load cells to the Arduino
Next, connect the signal wires from each HX711 load cell amplifier module to the analog input pins on the Arduino. You can connect multiple load cells to the same Arduino by connecting each signal wire to a different analog input pin. Make sure to also connect the excitation and ground wires from each module to the appropriate power and ground pins on the Arduino.
Step 3: Upload the code to the Arduino
Now that your load cells are connected to the Arduino, you will need to upload the code to the Arduino using the Arduino IDE. You can find sample code online that will help you read the weight values from each load cell and display them on the serial monitor.
Step 4: Calibrate your load cells
Before using your load cells in a real-world application, it is important to calibrate them to ensure accurate weight measurements. You can do this by placing known weights on each load cell and recording the output values. Use these values to create a calibration curve that will allow you to accurately convert the raw data from the load cells into weight measurements.
By following these steps, you can easily connect multiple HX711 load cells to an Arduino and create a high-precision weighing system for your project. Whether you are building a DIY scale or a complex industrial control system, this setup will provide you with accurate and reliable weight measurements. So go ahead and start experimenting with multiple load cells and Arduino today!
https://maps.app.goo.gl/jgBjMS3mZYiTGFWx9